Colfax approves 2020 street use permit for Timber Tech
PROTECTED CONTENT
If you’re a current subscriber, log in below. If you would like to subscribe, please click the subscribe tab above.
Username and Password Help
Please enter your email and we will send you a password reset link.
By LeAnn R. Ralph
COLFAX — The Colfax Village Board has approved the 2020 street use permit for Timber Technologies that allows semi-trucks to use Third Avenue and Cedar Street to reach the rail spur on Legion Drive.
The street use permit for Timber Tech is an annual permit issued by the village board, explained Lynn Niggemann, village administrator-clerk-treasurer, at the Colfax Village Board’s April 13 meeting.
The village board met remotely using the online program Zoom so that board members did not have to be in the same room as part of the social distancing guidelines during the COVID-19 coronavirus pandemic. Members of the public can also observe the meeting through Zoom.
Scott Gunnufson, village president, asked if Tom Niska, co-owner of Timber Technologies, had any concerns about using the streets to reach the rail spur.
The semi-trucks haul lumber products made at the Timber Technologies facility on Bremer Avenue to the rail spur on Legion Drive for loading onto rail cars.
The trucks turn on Third Avenue and then turn right on Cedar Street, and unfortunately, there is no better option at this point, Niska said.
Signs
When the street use permit was first granted for Timber Technologies, there was discussion about putting up signs to warn drivers that semi-trucks would be using residential streets, said Village Trustee Mark Halpin, who lives on Cedar Street.
Timber Tech started out using orange cones as a way to let drivers know about the truck traffic, but when cars are parked along the street, the semi-trucks need to make a wide turn, and the cones were run over, so the cones were not especially useful, Niska said.
Signs could certainly be put up. Where should the signs be placed? And what should they say? he asked.
When the trucks go to the rail spur, they do not stop at the stop sign, Halpin said, estimating that more than 50 percent of the truck drivers do not obey the stop sign.
Cedar Street also “does not have to be a race track,” he said.
Even though the semi-truck drivers are contractors and are not employees of Timber Technologies, Niska said he would remind them to stop at the stop signs and not to roll through them or “blow them off” completely.
Halpin said he realizes the semi-trucks need to take a wide corner to turn on Cedar Street and noted that he owns the property by the intersection.
Halpin said he would like to see signs reminding drivers to slow down.
With the COVID-19 pandemic and school not being in session now, there are children who play out in the street at times, he said.
Niska reiterated that he does not want the trucks to roll through the stop signs and that he would talk to the company.
The three seconds the trucks would need to stop will not make “a life or death” difference for reaching the rail spur, he said.
Portable signs
Niska said he could get the 36-inch by 36-inch orange diamond-shaped signs with a wide base to put up on Cedar Street and wondered where they should be placed.
Halpin suggested the signs could be put at the edge of his yard.
“If you’re okay with it,” Niska said, adding that he would not want the signs to take up space in the roadway.
Halpin said he had no objections to the signs being placed in his yard.
Which way should the signs be pointed? Niska asked.
Halpin said the signs should be placed so they can be seen from the north and from the south.
The signs are only one sided, so it would take two signs so they could be seen from both directions on Cedar Street, Niska said.
Niggemann said she had gone back to the minutes and had listened to the tape of the meeting when the signs had been discussed.
The purpose of the signs was for the property owners, and a concern was how often they would have to be taken down and put up, she said.
A better strategy than signs might be for Timber Tech to remind the drivers about the stop signs and the speed limit of 25 miles per hour on residential streets, Niggemann said.
If the truck drivers are not following the stop signs, they will not follow any other signs, she said.
Village Trustee Margaret Burcham said she did not see a need to waste money on signs.
Village Trustee Carey Davis suggested that it would useful for the Colfax Police Department to monitor the stop signs on Cedar Street.
Niggemann said she would speak to Colfax Police Chief William Anderson about monitoring the truck traffic on Cedar Street.
Having the police squad sit there at times would be a good idea, Niska said.
The Colfax Village Board unanimously approved the street use permit for Timber Technologies.

